Baler dengan ikatan silang 8 kali ganda

Presona AB LP 80 VHK 1

Technical data baler:
Manufacturer Presona AB
Typ LP 80 VHK 1
Year of construction 2012
Total machine operating hours 25,895 hours, as of July 2025
Pump operating hours, effective 14,135 hours, as of July 2025
Number of bales pressed 235,597 pieces, as of July 2025
Press power main press 78,5 tons
Specific press capacity 95 N/cm²
Press power of pre-press 28 tons
Volume of pressing chamber 2,7 m³
Feed channel1,500 x 1,100 mm
Theoretic throughput rate 930 m³/h
Throughput rate under operating conditions 410 m³/h
Bale size 750 x 1,100 mm
Driving motor 55 kW
Tying system 5 fold vertical, 3-fold horizontal, full automatic
Throughput rate with a bulk density of
30 kg/m³ approx. 9 to 12 tonnes/hour, depending on material
50 kg/m³ approx. 14 to 17 tonnes/hour, depending on material
100 kg/m³ approx. 16 to 25 tonnes/hour, depending on material
Throughput capacity with MSW (Municipal Solid Waste) approx. 20 to 27 tonnes/hour, depending on material
Bale weight 450 up to 600 kg, depends on material and bale length
Volume hydraulic oil tank 1,000 l
Baler dimensions built up with hopper 10,985 x 3,750 x 4,310 mm (l x w x h)
Transport dimensions only baler 10,985 x 2,300 x 2,900 mm (L x w x h)
Machine weight baler approx. 24 tons

Condition of the press:
The machine was partially overhauled and serviced in our workshop and, once the work was complete, tested in manual and automatic mode during operation.

The following overhaul work was carried out:
Machine cleaned, partially derusted and partially repainted
Hydraulic oil tank emptied and cleaned
Oil filter and air filter replaced, new hydraulic oil filled
Press ram dismantled and cleaned
All four rollers removed from the press ram and replaced
Wire station with deflection rollers for the lower wire cleaned and made operational
Side guides removed from the press ram, smoothed, mounted and readjusted
Main hydraulic cylinder dismantled and disassembled for inspection
Piston rod replaced, cylinder tube honed
Complete seal set replaced, pressure test carried out
Njdpfxsvwlqqj Ag Hocn

Vertical and horizontal needle system for binding dismantled, cleaned, wire deflection rollers made functional and serviced
Chain cleaned, greased, chain tension readjusted
Drillomat cleaned, wire knife, drill shafts and drill fingers checked, retightened with torque and serviced
Door contact switch checked and partially replaced.
Emergency stop switch checked.
Complete electrical wiring checked and partially replaced.
Bearings of the wire guide rollers under the press replaced.
New safety grilles for vertical and horizontal binding manufactured and installed.
Machine checked, general maintenance work carried out and press tested in manual and automatic mode

Scope of delivery:
Only the baler will be sold.

Comments:
The documentation (Manual, CE-declaration, electr./hydr.-drawings), are completely available. Inspections are possible after agreement. We will not assume liability for the given technical data and possible errors.