Rak tugas berat

Kragarmregal einseitig Höhe: 2.600 mm Nutztiefe: 1.000 mm / Länge: 4.000 mm

Cantilever rack used: screw system in hot-dip galvanized design

Scope of delivery:

4 shelf uprights, height 2,600 mm with foot section, 1,000 mm usable depth

Psdemhh Dzepfx Ai Horb
12 cantilevers with 1,000 mm usable depth, standard

Including longitudinal and diagonal braces for 1,300 mm spacing

Fastening material (screws, nuts and washers)

- (*Delivery time approx. 1 week)

- (*No damaged parts!)
- (*Reorder spare parts and extension possible at any time)

- (*Offer available in larger quantities: approx. 40 uprights in stock)

Detailed description:

- Stable steel construction made of IPE profiles (screw system)

- Hot-dip galvanized surface

- Shelf height 2,600 mm

- Load capacity per upright 1,800 kg

- Foot section and cantilever arms with 1,000 mm usable depth

Cantilever arms in Height adjustable in 100 mm increments
- 3 screwable cantilever arms per stand, standard (= 4 storage levels)
- Load capacity per cantilever arm 600 kg
- Including longitudinal and diagonal braces for 1,300 mm spacing
- Shelf length = 4,000 mm
- Including fastening material (without ground anchors)
- With assembly instructions and C4 load plates in accordance with DIN standard

- Expert advice by telephone
- Made in Germany
- Short delivery time
- On-site collection possible

Our cantilever racks are manufactured exclusively in Germany.

We offer reliable freight with registration before delivery.

The material is sensibly packed to enable easy unloading.

When installed outdoors, the load-bearing capacity is reduced by the wind and snow load.

The subsurface must be made of concrete, level and dowel-capable and must be able to bear the loads. The condition of the soil and load-bearing capacity as well as any official permits required must be checked and guaranteed by the customer.

The shelf supports must be anchored to the floor on site; anchoring to the wall is not necessary and not recommended.
According to the trade association, it is recommended that the shelf supports on the top storage level have a projection of at least 500 mm above the top edge of the supports.

Iklan ini diterjemahkan secara automatik. Mungkin terdapat kesilapan terjemahan.