Treler Tandem

Fliegl Tandem-Tiefbett-Anhänger TTS 100 4,5m

Customized transport solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are carried out individually according to customer requirements.

Chassis, central axle trailer, low-bed
Fine-grained steel welded construction
Gear-supported front leg
Telescopic rear support
2 chock blocks with holder
Fenders made of steel sheet over both wheels
Aluminum side impact protection
Coupling device for central axle trailer
Drawbar with tested 40 mm drawbar eye
Drawbar height-adjustable via spindle, max. adjustment range 250 mm
Axles + Suspension
BPW drum brake axles
"Axle/chassis laser-aligned" – reduces tire wear and fuel consumption
Klsdpji Ri Ebjfx Al Asu
Parabolic suspension with maintenance-free steel-rubber bearing and mechanical axle load compensation (rocker compensation)
Wheels and tires
235 / 75 R 17.5"
according to manufacturer's choice
Steel rims, factory silver
Braking system
2-line compressed air braking system
Spring-loaded parking brake
2 fail-safe coupling heads at the front, with connecting lines to the towing vehicle
24 Volt ABS and ALB, with ABS plug at the front, with connection cable
Note: The trailer may only be towed by towing vehicles that ensure the effectiveness of the ABS!
Electrical system
24 Volt, multi-chamber lights, yellow LED lighting on the sides
2 white position lights at the front
2 white/red side marker lights at the rear
2 x 7-pole fail-safe plugs at the front, with connection cable
Platform TTS
Low-lying steel pan, platform floor made of steel/diamond plate, steel walls welded to the floor
Platform length 4500 mm
Pan with "Load-Lock profile" at the front and on the sides for attaching lashing straps
(8 pieces at the front, 12 pieces on each side)
Note: Slight unevenness in the floor may occur due to welding distortion!
2 pairs of lashing eyes, 1 x at the front in the corners of the steel pan and 1 x at the rear in the floor, each 5 tons.
Loading ramps
Steel ramps 2,300 mm long, 510 mm wide, laterally adjustable
with handrail on the ramps
covered with wood (tip area with steel/diamond plate)
with gas spring for single-person operation
Operating instructions
The specified total weight is technically possible, but depending on the load, the total weight may not be reached while observing the permissible axle/support and saddle loads. (Poor driving and tracking behavior possible due to incorrect load distribution)
Country of registration/Signs
Country of registration: Germany
with Dekra inspection and certificate (according to §13 EG - FGV)
24/7 service hotline
prepared for single-line license plate holder
Contour marking with reflective tape according to ECE R 048, white on the sides and red at the rear
Painting
Frame painted or galvanized, according to customer request
Loading ramps, hot-dip galvanized

Customized transport solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are carried out individually according to customer requirements.

Iklan ini diterjemahkan secara automatik. Mungkin terdapat kesilapan terjemahan.