Treler platform

FLIEGL Tridem-Plattform Anhänger TPS 300 Bau

Customized transport solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are customized according to customer specifications.

Chassis – Central axle trailer design
Fine-grained steel welded construction
Lsdszcv D Njpfx Ab Ajhn
Gear-supported front leg
Hydraulic rear supports
Wheel chocks with holder
Aluminum side impact protection
Without under-run protection
Mud flaps at the rear, covering the entire width
Mud flaps in front of each axle and anti-splash mud flaps behind each axle
Plastic tool box, with insert, w=620/h=360/d=440 mm, lockable with a padlock
Extendable widening elements to 3,000 mm
Storage compartment for wooden planks in the center + wooden planks 70 mm for widening to 3,000 mm
Tie-down points for low-bed trailers
Recessed ring-type tie-down points in the outer frame, each rated at 5 tons (can be converted to stake pockets)
Tie-down eyes at the top and on the sides in the outer frame, each rated at 10 tons
Towing device – Central axle trailer
Drawbar with a tested 50 mm tow hitch
Axles + Suspension
Drum brake axles
"Axles/chassis laser-aligned" – reduces tire wear and fuel consumption
Last axle with trailing arm steering, with automatic reversing lock controlled via the reversing light, and an additional locking function on the vehicle via a manual button.
Air suspension
1st axle – automatic lift axle, additionally manually lowerable, operable with a button on the vehicle
Axle lift below the recommended driving height, therefore no guarantee for tire damage
Braking system
2-line compressed air braking system, color-coded lines for easy servicing
Spring-loaded parking brake
2 fail-safe coupling heads at the front, with connection lines to the towing vehicle
EBS, electronic braking system with EBS connector at the front, with connection cable
Note: The trailer may only be towed by towing vehicles that guarantee the effectiveness of the ABS!
With lifting and lowering valve
Vehicle height in conjunction with the lift axle; when the lift axle is raised, the loading or overall height increases by 50 mm
Vehicle – Driving stability system
Trailer Info Center for displaying vehicle data such as axle loads, mileage, and diagnostic/system messages
Axle load detection via EBS-CAN bus signal for display on the display in the cab
Wheels and tires
235/75 R17.5, manufacturer's choice
Steel rims, factory silver
Electrical system
24 volts, multi-chamber lights in LED with resistor, yellow LED lighting on the sides, license plate lighting in LED
2 white position lights at the front in LED
2 white/red marker lights at the rear in LED
2 x 7-pin fail-safe plugs at the front, with connection cable
Additional LED work light at the rear
LED rotating beacon with mount
Warning signs, LED illuminated and extendable to 3,000 mm
Floor
Subsequently with 70 mm softwood flooring, steel/diamond plate covering in the wheel arch area
Rear slope with 70 mm softwood flooring
Low-bed platform including rear slope 7,500 mm
Ramps
Steel ramps, 2,800 mm long, 750 mm wide, laterally adjustable
Covered with wood
Hydraulically operated via towing vehicle’s auxiliary drive with throttle, operation on the left side in the front
Hydraulic lateral adjustment of the ramps, individually controllable
Hydraulic connection with quick-release coupling NW 10/3, including connection hose

Customized transport solution

Iklan ini diterjemahkan secara automatik. Mungkin terdapat kesilapan terjemahan.