Bunk terbuka

Fliegl SZS 280 Jumbo Plateau

Customized transport solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are customized according to customer requirements.

More information
Chassis, semi-trailer, transport company
Fine-grained steel welded construction, kingpin plate with 2 replaceable kingpins
Outer frame slightly inclined, new design with Load-Lock profile for attaching lashing straps
24 tons, 2-speed landing gear, single-sided operation, with straight lower part, without push-pull compensation
Free support foot angle or free swivel radius to the rear, approx. 1920 mm
2 chocks with holder
Aluminum side underrun protection
Steel rear underrun protection
Quarter panel fenders in front of and behind each axle
1 spare wheel holder for 1 spare wheel, with wheel fastening kit
1 plastic toolbox, with insert, w=620/h=360/d=440 mm, lockable with a padlock. (Lock not included)
Axles + Suspension
Drum brake axles, selection according to manufacturer
Laser-measured axle/chassis alignment, reduces tire wear and fuel consumption
Air suspension
Braking system
2-line compressed air braking system, color-coded lines for easy servicing
Hsdpfx Aekv Uvzobpjp
Spring brake parking brake
Duomatic connection at the front, without connecting line
EBS, electronic braking system with EBS socket at the front, without connecting cable
Note: The trailer may only be towed by towing vehicles that ensure the effectiveness of the ABS!
with lifting and lowering valve
Vehicle - driving stability system
Wheels and tires
235/75 R17.5, manufacturer's choice
Steel rims, factory silver
Electrical system
24 volt, multi-chamber lights, yellow LED lighting on the sides
2 white position lights at the front
2 white/red marker lights at the rear
1 x 15-pin socket at the front, without connecting cable
Floor
Sieve-printed panels, approx. 30 mm thick, for high point load capacity, for forklift axle load up to max. 5,600 kg
Front wall / corner posts
25 mm aluminum hollow profile, approx. 1,350 mm high, corner posts made of steel in a volumetric design
Country of approval / plates
Germany
with Dekra inspection and certificate (according to §13 EG - FGV)
24/7 service hotline
prepared for single-line license plate holder
Contour marking with reflective strips according to ECE R 048, white on the sides and red at the rear
Paintwork
Frame hot-dip galvanized including passivation, 15 years warranty against rust
Front wall aluminum
Note: These are archive images!

Customized transport solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are customized according to customer requirements.

Iklan ini diterjemahkan secara automatik. Mungkin terdapat kesilapan terjemahan.