Lori kayu

Fliegl SDS 380 Holzrungenaufbau

Further information
Chassis semi-trailer forwarding
Welded steel construction in reinforced design, only 2 side members as double T-beams with steel/checker plate between the side members, saddle plate with replaceable 2 kingpins. Protective plate for rear lights.
1 steel storage box, recessed between side members
8 pairs of lashing eyes bolted or welded to the frame at the manufacturer's choice
24 t. 2-speed support winch, single-sided operation, with straight lower section, without thrust compensation
2 wheel chocks with holder
Aluminium side bumper
Galvanized steel underride guard
Half-shell mudguards
with anti-spray flaps according to EC
1 spare wheel holder for 1 e-wheel, with wheel fastening set
8 wooden stanchions of the manufacturer's choice, bolted to frame with 2 wooden stanchions each, telescopic from 1800 to 2800 mm, per pair 7 to.
Axles + suspension
SAF disk brake axles with 430 mm disk diameter
Air suspension with lifting & lowering valve, safety cable on the axles
1st axle automatic lift axle, including forced lowering and starting aid, actuation of 3x brakes (starting aid is functional up to an axle load excess of 30% and up to a speed of max. 25 km/h)
Axle spacing offset mm (combined transport) up to 44 tons gross train weight
Wheels and tires
385 / 65 R 22,5
at the manufacturer's discretion
Steel rims, factory silver
Brake system
2-line compressed air brake system
Spring-applied parking brake
Axle load detection via EBS-Canbus signal, for indication via display in the cab, truck must be prepared accordingly, no truck installed (no calibrated scales)
2 swap-proof coupling heads at the front, without connecting cable
EBS, electronic brake system with EBS socket at the front, without connecting cable
Attention: The trailer may only be towed by towing vehicles that guarantee the effectiveness of the ABS!
Electrical system
24 volt, multi-chamber lights, amber LED lighting at the side
2 white position lights at the front
2 white/red lane departure lights at the rear
2 x 7-pin and 1 x 15-pin interchangeable sockets at the front, without connecting cable
Front bulkhead/front stanchions
Steel/grid bulkhead, approx. 2,300 mm high, bolted to the frame
Approval / plates
Country of approval: Germany
Approval according to EC 2007/46
Prepared for single-line license plate holder
Contour marking with reflective strips in accordance with ECE R 048, white at the sides and red at the rear
Paint finish
Frame DB 7350 nova gray
Nedpfei Rivwsx Agpewr
Black coated support legs
Front wall hot-dip galvanized
Attention: Archive pictures!

Iklan ini diterjemahkan secara automatik. Mungkin terdapat kesilapan terjemahan.