Treler separa terbuka dengan kanvas

FLIEGL Gardine Standard SDS 350

Chassis Semi-Trailer, Forwarding

Fine-grain steel welded construction in reinforced Scandic design, fifth wheel mounting plate with interchangeable 2" kingpin
Outer frame slightly inclined with "Load-Lock profile" for lashing strap attachment
Note! When attaching straps in combination with side walls, the side walls must be opened!
Lashing rings for insertion into the "Load-Lock profile", each rated at 6 tons, loose
24-tonne 2-speed landing gear, single-side operation, with straight lower section, without compensation plate
Free swing radius to landing gear foot approx. 2200 mm, landing gear foot distance approx. 2350 mm
2 wheel chocks with holder
Side underrun protection (aluminium)
Rear underrun guard (galvanised steel)
Quarter-shell mudguards in front of and behind axle unit
With anti-spray mudflap on rearmost axle only
1 plastic toolbox, with drawer and shelf, W=650 / H=520 / D=670 mm, lockable with padlock (padlock not included)
1 pair stanchion sockets integrated at the very front in the outer frame/floor, 83 x 83 mm internal size
2 plug-in stanchions, W=80 / D=80 / L=1200 mm, hot-dip galvanized
Note: Stanchion sockets / plug-in stanchions are not designed for securing long loads, pipes, etc. without wrapping
4 pairs ferry lashing rings, marked yellow

Axles + Suspension
3x BPW drum brake axles
"Axle/chassis laser alignment" to reduce tyre wear and fuel consumption
Air suspension

Braking system
2-line compressed air braking system
Colored air line routing for easy servicing
Spring-loaded parking brake
2 non-interchangeable coupling heads at the front, without connecting pipes
EBS: Wabco Premium, Electronic Braking System with EBS socket at the front, without connecting cable; Wabco Premium includes open CAN BUS for telematics
Note: Trailer may only be towed by tractors that ensure proper ABS functionality!
With raise & lower valve
Vehicle stability control system

Electrics
24 Volt, multi-chamber lights in LED with resistor, side yellow LED lighting, license plate LED lighting (Note! Certain towing vehicles may display diagnostic errors, even if functionality is assured)
2 white position lights at the front
2 white/red lane marker lights at the rear
Redox Rq Slepfx Agpsl
2 x 7 pole non-interchangeable sockets at the front, without connecting cable

Front wall / front corner posts
2 front corner posts, 580 mm high, steel in volume spec, release device for side curtain at the front wall
"Crash blocker", lower inside at approx. 140 mm high with steel impact guard

Insert slats
Rows of wooden insert slats

Curtain
Curtain with welded horizontal and vertical belts
Tension locks made of stainless steel

Floor
Slip-resistant plywood, approx. 30 mm thick, on longitudinal beams for high point load capacity, suitable for forklift axle loads up to max. 7,100 kg
Note: Floor deformation due to weather is possible (no warranty)!

Rear wall / rear corner posts
Rear corner posts in steel up to lower edge of roof, curtain suspension with round tube and curtain tensioning ratchet
Rear portal doors, double-winged with 2 internal rod locks each

Roof
Sliding roof, rear end-liftable, sliding from rear to front, curtain color: white
Optimized rain gutter at rear, on upper end crossmember, above doors

Country of registration / Plates
Germany
EC type approval 2007/46
24/7 service hotline
Prepared for single-line license plate holder
Contour marking with reflective tape per ECE R 048, white side markings and red rear markings

Iklan ini diterjemahkan secara automatik. Mungkin terdapat kesilapan terjemahan.